Quick Fixes To Repair A Hole In Your Window Screen

If you noticed a window screen in your home has a hole in it, you will undoubtedly want to take the necessary steps to repair or replace it. Failing to fix the hole can lead to an abundance of insects in your home, making it necessary to do repair work quickly if you want to keep your window open. Here are some tips you can use to fix a hole in your window screen on your own.

Try Some Clear Glue And A Pair Of Tweezers

If the hole in your screen is smaller than the size of a pea, you may be able to patch it using tweezers and glue. Use the tweezers to attempt to twist the ends of broken strands of wire back together. Afterward, a dab of clear contact cement can be placed over the affected area to seal the wire into place. Apply it on both sides of the screen where the hole was located for the best results. Do not touch the cement for several hours so it has a chance to adhere and dry.

Get Out Your Thread And Needle To Make A Patch

A hole that is larger than a pea, but smaller than a few inches can be covered up with a new piece of screen. This can be purchased in a hardware store. To make the hole less noticeable, remove the framed screen from your window and use a pair of scissors to cut the jagged edges of the hole into a square shape. Cut a piece of screen into a square shape a bit bigger than the square hole. Center this piece of screen over the hole and use clear fishing line to sew it into place. 

Replace The Entire Screen To Eliminate Holes

If there is a larger tear in your screen, it will be necessary to remove the entire screen from the window frame and replace it with a new piece. Use a screwdriver to pry the pieces of spline from each edge of the screen window. These are the pieces that hold the screen into place. The mesh is most likely stapled into place. Use a staple remover to take these staples out. Cut a piece of wire screen a bit larger than the opening of the window screen frame. Center it over the opening and use a stapler to adhere it into place, attempting to keep the material taut as you do so. Use a utility knife to cut away any excess material. Replace the edging and place the screen back into the window.

For more information, contact local professionals like Northridge Screen.


Share